Function target info

[xortexx]

Hi,

Function to find the information on the target do not work in the source code of Prophet Bot. Yet when we launch the EXE information is displayed well.
Have you any idea of the problem?

Global $OFFSET_TAR[3], $CFG_OFFSET_TAR = "Target_OffSet", $MOVETONPC = 0, $NOTARGETS = 0, $DEAD = 0
$OFFSET_TAR[1] = IniRead($SOFTWARE_OFFSET_CONFIG, $CFG_OFFSET_ROOT_KEY, $CFG_OFFSET_CHARSTRUCT1, "52")
$OFFSET_TAR[2] = IniRead($SOFTWARE_OFFSET_CONFIG, $CFG_OFFSET_ROOT_KEY, $CFG_OFFSET_TAR, "")

$tar_temp = _MemoryPointerRead($APP_BASE_ADDRESS, $PROCESS_INFORMATION, $OFFSET_TAR)

$tar_temp is always 0.

[martmor]

Hello

Two possibilities:

1) The offsets are wrong
2) you use not the original prophet bot Script

[xortexx]

offset:
Target_offset = 3036
OFFSET_TAR $ [1] = 52
OFFSET_TAR $ [2] = 3036

normally they are good because they work with the exe. But when I compile the file au3 does not work.

[martmor]

If you use the original prophet Bot Script then you have a mistake in the offset file.

Correct it is in the Offset ini file:

Target_OffSet=3036

[xortexx]

I use the original script well, at least I think. The offsets are necessarily good because it works with the executable, but when I compile the source code "au3" does not work.

[martmor]

At the original Prophet Bot Script is only the real base address and sendpacket address in the source code to change. all other keep as it was original.

[xortexx]

I found where does my problem. Target Info function did not work because I had 3.3.8.1 version of AutoIT, I installed version 3.3.6.1 and now its working ..... find the error ^ ^