ok, this is what confuses me in the tut.
"Once you found your Delay Time in Milliseconds go back to your uce and in scan bar type in your delay time and set your type to four byte exact scan and click new scan....
You'll see few addresses click all of them and make them all "1" and freeze it!"
6000 should be right according to:
( skill
( key "archer-18")
( name "Life Absorption")
( limit archer)
( action 18)
( image "active063")
( desc "#nReduce the target's HP and absorb some part of the HP.")
( ability "#nEnergy used : %1!d!")
( parameter 1 ( plus 20 ( mul skill_level 6)) )
( level 50 57 66 0) ( grade 11 0)
( maxlevel 1 2 3 0)
( compare 1 ( plus 20 ( mul skill_level 6)) )
( compare 2 160)
( compare 3 0)
( compare 4 6000)
( type active use)
( motion 0 11 none )
( damagetype 1)
)
6 seconds.
But i get 200+ results. what am i doing wrong?