I am using the steal archer server pack, and have the powersourceco client.
I will mark the area I had trouble with in red, and leave a note on what I think I did wrong, I really need help. I followed this guide from portforward.com for my uverse 2wire gateway, but no one is able to connect to my server.
These are the steps I followed, and I used these ports
1. 9528/tcp
2. 9958/tcp
3. 5816/tcp
"Open a web browser like internet explorer or Netscape. Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has
in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.1.254. Click the Firewall button.
Click the Firewall Settings button.
When I got to the step below, click the link to see image, I changed
From: 5816 To: 9958
Protocol Timeout: 86400
Map to host port: I left blank
Application Type: None
Use the Select a computer box to choose a computer to forward ports to. This box contains a list of computer names that are visible on your network. Click the Add a new user-defined application link.
Enter the name of the program into the Application Name box. It doesn't really matter what you put into this box, but something that will remind you why these ports are being forwarded would be a good idea. Select the protocol type using the Protocol radio button. If you need both TCP and UDP, create a duplicate configuration. The first configuration would have TCP selected, while the second one would have UDP selected. If you are forwarding a single port, enter that port number into the Port (or Range) From and the Port (or Range) To boxes. If you are forwarding a range of ports, enter the lowest number of that range into the Port (or Range) From box. Then enter the highest number of that range into the Port (or Range) To box. Enter the protocol timeout into the Protocol Timeout (seconds) box. The protocol timeout should be set to 86400 if you are using the TCP protocol, or 600 for the UDP protocol. Go ahead and leave the Map to Host Port box empty. Leave Application Type set to None. Click the Add Definition button. Click the Back button.
Select the applications you just created in the Applications list, then click the Add button to move them to the Hosted Applications box.
When you are finished, click the Done button at the bottom of your screen.
And that is it! You are done!
To test if your port has been properly forwarded, you can use our Port Checker tool."
