Da viele USER kein bock haben zu suchen ,
werd ich es euch hier mal hinn schreiben!
Also wie bekomme ich es hinn das kein ERROR kommt wenn ich engine.exe mit zenoseengine ect- öffne.!
Hier is die Lösung ^^...>
General Settings:
Tick Everything except Address list specific
Scan Settings:
[ ] Fast scan on by default
[x] Enable hyperscan when possible
[ ] Don't scan memory that is protected with the No Cache Option
[ ] Keep low memory usage when doing an "Unknown Initial Value scan" with Hyper Scan
[x] MEM_PRIVATE
[x] MEM_IMAGE
[ ] MEM_MAPPED
[X] Run scan in seperate thread.
File Associations:
Tick Nothing
Code Finder:
[x] Use Debug Registers
[ ] Memory Access Exceptions
[x] Try to prevent detection of the debugger
[ ] Handle breakpoints not caused by CE
Assembler:
[x] Show disassembler
[x] Show debugger options
[x] Use hardware breakpoints
[ ] Use int3 instructions for breakpoints
[x] Replace incomplete opcodes with nops
[x] Ask for replace with nop
[x] Try to prevent detection of the debugger
Extra:
[ ] Query memory region routines
[x] Read/Write process memory
[x] Open Process
[ ] Use APC to inject dll's
[ ] Use APC to create new threads
[ ] Undo changes to CE
[ ] Force memory to be writable in case the standard method is blocked
[x] Enable use of Process Watcher
[x] Use kernel debugger options when possible
[ ] Stealth mode (Usermode)
[ ] Stealth mode (Kernelmode)
BY SYNTEX! hier is von sytex aber karma wäre sehr nett mit diesen settings sollte der error behoben sein
Ps: Könnte das nicht Pinned?
Dan würde es euch auch ein wenig erleichtern .!
Dan würden hier nicht noch mehr unnötige Threads kommen
Wie z.b >WIE GEHT DER ERROR WEG
 |
