![[AIMBOT!] GzBotPro CRACKED !](https://www.elitepvpers.com/forum/iconimages/general-gaming-discussion/aimbot-gzbotpro-cracked_ltr.gif){kind=small}
But download if u want.
Short instructions:
Only for Gunbound Revolution
1. Launch GzBotPro before GunBound! (VISTA users >> right click & run as Administrator)
2. Launch GunBound
3. Wait for the message: "GBNA detected"
(If you don't get this message, GzBotPRO won't work!)
1 - Select your bot by pressing CTRL+B (see HotKeys for more options)
2 - Set up your position by pressing CTRL + left mouse click (or ALT + right mouse click) on the begin of the red arrow
(see in picture >> yellow cross). Do NOT click on the MIDDLE of your bot!
3 - Set up your enemy's position by pressing CTRL + right clicking on the MIDDLE of enemy's bot
Turtle's Forks:
1. Mark your position (base of the red arrow, not the middle of you bot!) by pressing CTRL+left mouse click OR ALT+right mouse click
2. Mark your enemy's position (middle of enemy's bot) by pressing CTRL+right mouse click
3. Press PAGEUP for Turtle's Forks
(You will get then the proper angle & power)
Turtle's TimeBomb/SkyBomb:
1. Mark your position (base of the red arrow, not the middle of you bot!) by pressing CTRL+left mouse click OR ALT+right mouse click
2. Mark your enemy's position (middle of enemy's bot) by pressing CTRL+right mouse click
3. Press CTRL+SHIFT
(white line = angle & power for TimeBomb, blue line = angle & power for SkyBomb)
Notes:
For TimeBomb, adjust enemy's position few pixels above their bot.
SkyBomb: The best distance is 1/2 screen to 3/4 screen. For distances up to 1/2 screen ADD 1 angle. For distances further than 3/4 screen SUBTRACT 1 angle.
It's NOT possible to hit every spot using SkyBomb! There are approx. 11 horizontal spots on 1 screen where the SkyBomb hits perfectly. If the enemy is located between these spots, SkyBomb will miss.
Trico
1. Mark your position (base of the red arrow, not the middle of you bot!) by pressing CTRL+left mouse click OR ALT+right mouse click
2. Mark your enemy's position (middle of enemy's bot) by pressing CTRL+right mouse click (You will get the angle & power for 2 spins & 3 spins)
Note: There is no spin 1 (shooting left<<<)
Nak (Shot 2)
1. Mark your position (base of the red arrow, not the middle of you bot!) by pressing CTRL+left mouse click OR ALT+right mouse click
2. Mark the spot where the shot 2 goes into the ground & press CTRL+right click
Boomer Hooks
1. Turn on Boomer hooks by pressing CTRL+H
2. Mark your position (base of the red arrow, not the middle of you bot!) by pressing CTRL+left mouse click OR ALT+right mouse click
3. Mark your enemy's position (middle of enemy's bot) by pressing CTRL+right mouse click
(You will get the power for Angle 40 hook & the angle for the FULL power hook)
How to use Nado:
1. mark your position
2. place the cursor over the middle of nado & press INSERT (nado ON/OFF)
3. drag the power-line on the powerbar to get proper power
p.s. don't forget to turn off (INSERT) the NADO after u don't need it anymore
HACKS:
CTRL+SHIFT+K : Turn on AntiKick
HotKeys
CTRL+SHIFT : SCAN for Turtle's SS SkyBomb & TimeBomb
PageUp : SCAN for Turtle's Forks
PageDown : Backshot ON/OFF
CTRL+H : Boomer Hook 40 ON/OFF
CTRL+E : Close GzBotPRO
CTRL+M : Mirror ON/OFF
INSERT : Nado ON/OFF
CTRL + B : change bot
or for even faster bot switch:
RMouseclick+T: Turtle/Armor/Asate
RMouseclick+M: Mage
RMouseclick+I: Ice/Grub/JD
RMouseclick+N: Nak
RMouseclick+R: Raon
RMouseclick+F: Frog/Dragon
RMouseclick+O: Trico
RMouseclick+G: BigFoot
RMouseclick+A: Aduka
RMouseclick+K: Kal
RMouseclick+L: Lightning
RMouseclick+B: Boomer
RMouseclick+X: Phoenix
***********************************************
