Pc is not starting after cleaning it, ga x58a ud3r

01/24/2018 19:11 Freelancer1337#1
So I thought I could clean up my pc since I haven't done it in a long time. I disassembled everything and cleaned it and put it back together now it won't start up and I am getting no picture at all.

I already tried:
- another Psu
- another ram / no ram
- another graphic / no graphic
- other hdd/sdd / none of them
- changing the battery
- resetting cmos
- cpu without cooler heats up pretty quickly (don't worry only about 10sec tested)
- running only the cpu

I am stuck on the last part since I don't have another cpu or mobo.
The symptoms are always the same so I guess it has to be one of them. It is a gigabyte ga x58a ud3r mobo and a Intel core I7 970.

Symptoms:
The pc starts up when I press the power button the sb-voltage led flashes red and goes out, phase led are constant green green yellow yellow red red, ddr phase led are constant green yellow green yellow, fans are spinning, no post (don't know if it ever did), it does not turn off from alone, at least it seems so, if I stop the cpu fan it starts to spin again like 5 seconds later, it stays like this until I turn it off by pressing the power button for like 3 seconds.

I tried searching online for a solution but the posted fixxes didn't help me at all, and most of not all cases were about constant restarting.

Thank you for your time.

Ihr könnt gerne auch auf deutsch antworten ich dachte nur so erreiche ich mehr Leute.
01/24/2018 19:43 Verleihnix#2
Wie hast Du die Reinigung durchgeführt? Wurde an satische aufladung gedacht?
Wurden die besonderheiten von Lüftern bedacht, welche bei schneller bewegung z.B. durch staubsaugen oder druckluft als generator wirken?
Es wäre denkbar, das Durch statische entladung die elektronik beschädigt wurde.
01/24/2018 19:50 RatexIndex#3
Kling erst mal stark nach Mainboard defekt.
Bilder vom Anschluss aller Kabel am Mainboard wäre mal schön.

Speaker am Mainboard vorhanden oder ist die Anschlussmöglichkeit gegeben ?
01/24/2018 19:58 Freelancer1337#4
Ja an auf einer holzplatte (Schreibtisch und habe vorher die Beine (Metall) benutzt zum entladen. Staubsauger oder ähnliches habe ich nicht verwendet.

Kein speaker drauf und auch keinen da zum anschließen möglich wäre es aber Bilder folgen.
01/24/2018 20:11 RatexIndex#5
Auf den Bildern sehe ich kein RAM eingesetzt sehe ich da richtig ?

Setz mal bitte einen ein un mach nochmal ein Bild

Hier mal die Codes: [Only registered and activated users can see links. Click Here To Register...]
01/24/2018 20:23 Freelancer1337#6
Gleiches muster auch mit ram.

Die Codes beziehen sich af eine LED prüfkarte.
01/24/2018 20:39 RatexIndex#7
Ohh dann my bad
Aber ich Tippe dennoch auf MB Defekt.
01/24/2018 22:13 fenster3000#8
Man erdet sich auch nicht an Tischbeinen (auch wenn die aus Metall sind), sondern an unlakierten Heizungsrohren, Steckdosen oder Blitzableitern.

Würde noch mal gucken, ob wirklich alles richtig steckt.