I'll start this out how any other noob story starts...
So I was trying to set up my server you know... and now I'm two steps and a penny flick away from ripping out every single hair on my noggin.
I got the server and all set up fine and I was able to connect to the client on the same computer, and then I moved on to configuring it for my LAN instead.
I know that the server is set up properly for other computers to connect, but every time I try to start the client from my second pc... It crashes. Sometimes immediately, sometimes when I click the password box, and sometimes during the authorization process.
In any event, it will not carry through the entire login on pc #2 but the few times that I managed to pass the login screen, I was getting the authorization attempt on pc #1.
I can't figure out, for the life of me, what is causing it exactly unless there is a compatibility issue of some sort. If I change the ip in my server.dat on pc #2 the client will either not show the server and freeze or show the server but not connect to pc #1, depending on the ip I change it to.
As far as the config goes, all IPs are set to 127.0.0.1 except for the server IPs in the mastersocket scripts, there I used the lan IP for pc #1.
PC #1 operates on Windows XP Home SP2
PC #2 operates on Windows Vista Home Premium SP2(I think) x64 with CoEmu running in x32 compatibility mode
So any takes on this? :(
Edit: I'm thinking there was a thread for problems with CoEmu v2, but I'm way too tired and didn't check too far, so relocate me if necessary.
So I was trying to set up my server you know... and now I'm two steps and a penny flick away from ripping out every single hair on my noggin.
I got the server and all set up fine and I was able to connect to the client on the same computer, and then I moved on to configuring it for my LAN instead.
I know that the server is set up properly for other computers to connect, but every time I try to start the client from my second pc... It crashes. Sometimes immediately, sometimes when I click the password box, and sometimes during the authorization process.
In any event, it will not carry through the entire login on pc #2 but the few times that I managed to pass the login screen, I was getting the authorization attempt on pc #1.
I can't figure out, for the life of me, what is causing it exactly unless there is a compatibility issue of some sort. If I change the ip in my server.dat on pc #2 the client will either not show the server and freeze or show the server but not connect to pc #1, depending on the ip I change it to.
As far as the config goes, all IPs are set to 127.0.0.1 except for the server IPs in the mastersocket scripts, there I used the lan IP for pc #1.
PC #1 operates on Windows XP Home SP2
PC #2 operates on Windows Vista Home Premium SP2(I think) x64 with CoEmu running in x32 compatibility mode
So any takes on this? :(
Edit: I'm thinking there was a thread for problems with CoEmu v2, but I'm way too tired and didn't check too far, so relocate me if necessary.