Quote:
This makes no sense i don't get it lol.
I can run proxy with co or co without proxy without changing server.dats so what exactly is the point of making a changer to change original and edited one back and forth when there is no need ??
Abviously if you need to change your server.dat from edited to original to switch back and forth from proxy co and non proxy co your doin something wrong to begin with to even need this.
|
U need to change ure server.dat ips for qoproxy to work. This just changes them with a few clicks.
Quote:
|
how i can use proxy pls help me i dont know how i work it pls give me info s what must i do?
|
Ok.
1. At the top of the screen you will see in blue writing where it says "Qoproxy Server group for ini. Select your server which you go on in the box to your right.
2. Specify whether you want your conquer settings to be for Qoproxy or for no Qoproxy. Then just choose the servers which you want the settings changed for Qoproxy. Eg. If i select qoproxy for settings and then Fury server then ONLY the fury servers settings will be switched for qoproxy.
3. Browse for your server.dat file which is usually in your \conquer 2.0 folder.
4. Browse for your qoproxy.ini file which is in the folder QoProxy is in.
5.Check what your ip is and input it into the 4 textboxes down the bottom
THEN SAVE!!
This will switch your settings from default (NO COOL QOPROXY SPEEDHACK AND AIMBOT) for you to be able to use qoproxy.
If your game does not work PM me.
Or go through these steps again.
By pressing the default radiobutton in "Server.dat Configurations" and then pressing save, the server.dat file will be reset to its normal patch configurations.
Hope that helps everyone who uses qoproxy.
Hiyoal :)