I want to Release a Metin2 Bot
written by me (C++ so the debugging is much easyer than in C#)
the inovation is the debugging/errorlogog i developed for M2_D
if there is any Problem by using it it will create a logfile which i can improve it for a better version easy.
System Requirements:
Win XP / Vista / Win7 in Admin mode
(version 7 is 32bit i havent try it with 64bit )
(Confirmed running on: Tiny XP / P4 2.6GHz / 768MB RAM / 333er Bus o.O )
How does the bot work:
While running to the next WP the bot is Tabbing to seek for a valid
target... once found:
it gets in distance > Buffs up > Precast > Battle Sequence loop until the mob is dead (emergency checks) ...
it will autom. loot > agro check > Postcast HP > Postcast MP > REGenerateHP/MP? > moves to next WP
FAQ:
- The bot ONLY READS from memory (writes in fly mode ! )
- The bot only works with Metin Client in Focus (no background mode )
- Make sure to ENABLE auto approach target in Option
- At first Start input a Botname on Misc layer , Keysetname on Basic layer
- Make sure you are near 30m of a Waypoint for "Runbot"
- Most of the input files have tooltips if you hover over with the mouse! (input sec, min etc?)
- After manual edit of the battle sequence (ini file) don’t forget to save it and refresh the list in bot
Dont forget the Thanks Button please
written by me (C++ so the debugging is much easyer than in C#)
the inovation is the debugging/errorlogog i developed for M2_D
if there is any Problem by using it it will create a logfile which i can improve it for a better version easy.
System Requirements:
Win XP / Vista / Win7 in Admin mode
(version 7 is 32bit i havent try it with 64bit )
(Confirmed running on: Tiny XP / P4 2.6GHz / 768MB RAM / 333er Bus o.O )
How does the bot work:
While running to the next WP the bot is Tabbing to seek for a valid
target... once found:
it gets in distance > Buffs up > Precast > Battle Sequence loop until the mob is dead (emergency checks) ...
it will autom. loot > agro check > Postcast HP > Postcast MP > REGenerateHP/MP? > moves to next WP
FAQ:
- The bot ONLY READS from memory (writes in fly mode ! )
- The bot only works with Metin Client in Focus (no background mode )
- Make sure to ENABLE auto approach target in Option
- At first Start input a Botname on Misc layer , Keysetname on Basic layer
- Make sure you are near 30m of a Waypoint for "Runbot"
- Most of the input files have tooltips if you hover over with the mouse! (input sec, min etc?)
- After manual edit of the battle sequence (ini file) don’t forget to save it and refresh the list in bot
Dont forget the Thanks Button please