Command Line

I know this is probably a really newb question but is there anyway to get a command line up and enter

INSERT INTO `cq_levexp` VALUES ('1', '0', '0001', '864', '864', '0400', '160', '4', '1600', '4', '136024', '10', '75', '4', '0', '2', '1244160', '0');

into it to change the db. That would be much faster then going through all the db tables to manually change everything.

I know this is probably a really newb question but is there anyway to get a command line up and enter

INSERT INTO `cq_levexp` VALUES ('1', '0', '0001', '864', '864', '0400', '160', '4', '1600', '4', '136024', '10', '75', '4', '0', '2', '1244160', '0');

into it to change the db. That would be much faster then going through all the db tables to manually change everything.

So sorry for double post.. refresh did it >_>

#Reported- Repeat Thread you already made a thread, dont open a new one with the same info and same question
#ThreadsMerged - KA

please read? i said sorry? can't delete it now.. refresh made it.

To answer your question you'd need to use a query on navicat, just put that into a new query and run it , and i had to report it anyway so the mod knows to deleate the old one

ok thank you for the help :) I honestly didn't mean to double post. :S