Kmbox net Need help!

Hello everyone,

I’ve been using DMA for a while now and never had any issues—until recently with my KMbox Net. I took a break due to moving, but once I got settled and set everything back up exactly as before, my KMbox suddenly stopped working properly with aimbot.

The device connects fine with multiple tools, DMA reads are perfect, and everything appears normal. But the moment I enable aimbot and try aiming at an enemy, my crosshair either flicks away or jitters uncontrollably.

I’ve been waiting 5+ hours between one-word responses from the Discord support ticket, and their suggestions haven’t helped at all—so I’m hoping someone here might know what’s going on or has run into this issue before.

What support told me to try:
Increase interval overlay, increase smoothing, and lower FOV.
I did all of that—if anything, it made the issue worse. It now locks on for a millisecond and immediately flicks away, making it extremely obvious that an aimbot is active. I even tried swapping hotkeys thinking it was a stuck button, but that wasn’t the issue either.



KMbox Net Specs

KMbox Net: Bypass ON

Mouse: Logitech G502 Hero

Firmware: Updated to latest version



PC / Monitor Specs

Resolution: 3440 × 1440

Monitors: Dual setup (2x)

Processor: AMD

Ps: I've googled, contacted fellow dma homies and simply searched on here for a fix hopefull if someone posted about this issue but I can't find one so hoping this helps.

honestly never used kmbox myself so take this with a grain of salt, but i got a few friends who run them and a couple things come to mind:

first, when you moved, did anything change with your monitor setup? that ultrawide + dual monitor combo can mess with coordinate mapping sometimes. the flicking away thing usually means it's getting bad screen positions. try unplugging the second monitor temporarily and see if it behaves better.

second, bypass on is correct but try toggling it off/on again or do a full power cycle (unplug for a minute). net versions can act up after firmware updates sometimes.

third, that "locks on then flicks away" sounds like the aimbot is fighting against raw mouse input or smoothing is set weird. try cranking smoothing way up (like 70-80) just to test if it stabilizes. if it does, slowly lower it til it breaks.

also check which monitor windows thinks is primary. if the kmbox thinks game is on monitor 1 but it's actually on monitor 2, coordinates get fucked.

support telling you to increase overlay interval is kinda sus lol usually makes it worse.

wish i could help more but i don't run kmbox personally. just passing along what i've heard from others. hope you get it sorted man