Hi, I have a problem with my fuser. All green LEDs are solid like one red LED D1. Only 1 red LED D2 is blinking and I got a blackscreen when I start the fuser. All HDMI cabel are plugged in correctly and I tryed switching them out already. If I unplug the HDMI from my main pc my second pc is showing like normal but if I try that with only my main pc theres only a blackscreen like when all cabel are plugged in. The resolution on both pc is the same 1090x1080 120hz. Im new to this so its possible im forgetting something...
I got it running 1 time and the next day I got a blackscreen...
main pc
resolution: 1920x1080 120hz
bit depth: 10-bit
color format: YCbCr444
color space: SDR
secondary pc
resolution: 1920x1080 120hz
bit depth: 8-bit
color format: RGB
color space: SDR
The fuser works as long as the main pc is booting up and as soon as hes out of it the blackscreen takes over.
I dont know the model of the fuser but hes got a red dragon in form of a "D" on it dont know if that helps...
Can someone pls help me :) thx
I got it running 1 time and the next day I got a blackscreen...
main pc
resolution: 1920x1080 120hz
bit depth: 10-bit
color format: YCbCr444
color space: SDR
secondary pc
resolution: 1920x1080 120hz
bit depth: 8-bit
color format: RGB
color space: SDR
The fuser works as long as the main pc is booting up and as soon as hes out of it the blackscreen takes over.
I dont know the model of the fuser but hes got a red dragon in form of a "D" on it dont know if that helps...
Can someone pls help me :) thx
