Is anyone else having gittery and laggy esp on fuser and it taking forever to load player esp to overlay? Also how do I setup my macku it is working I can test it with macku flasher but bun fails to connect to it. Would it be easy to just use my net.
Bun DMA
08/05/2025 07:36
ProductiveYetti#1
08/05/2025 08:34
Annie12388#2
Do not shut down only one PC while the other remains on — this creates instability.Quote:
Is anyone else having gittery and laggy esp on fuser and it taking forever to load player esp to overlay? Also how do I setup my macku it is working I can test it with macku flasher but bun fails to connect to it. Would it be easy to just use my net.
🚫 Do not switch inputs (K4 button) while PCs are booting or in sleep mode.
📉 Always set the overlay PC to low resolution (1080p) and 60Hz output.
🧠 The main PC may use high refresh rates (e.g. 1440p@240Hz or 300Hz), as long as the overlay signal is stable.
🔌 Never unplug the monitor or computers while the fuser is active.
💾 If possible, back up the firmware (for advanced users only).