DMA card plugged in pc does not boot

hi guys
i got myself a dma card (35t phoenix).
when i plug the card into my main pc and start it my windows hangs and does not boot.
I have done all the bios settings
bios update too
new windows 10 pro installed
the pc does not start ...
when i press the button on the dma card my screen does not receive a picture and does not turn on ...

I am completely new to this field :confused:...

change your PCI slot and try it again.

i change it but not work

msi b560m Pro...

do i have to install the firmware on my radar pc first ...i didn't really understand the explanations are good but nobody says if it has to be on main or radar pc

Quote:

Originally Posted by qu0n hi guys i got myself a dma card (35t phoenix). when i plug the card into my main pc and start it my windows hangs and does not boot. I have done all the bios settings bios update too new windows 10 pro installed the pc does not start ... when i press the button on the dma card my screen does not receive a picture and does not turn on ... I am completely new to this field :confused:...

Seems like your DMA card is broken. It should boot normally. gg's buy new one.

It could be hardware compatibility issues, If it's not compatibility issues then the card itself could be defective. Try testing it on another system.

No one really?

It might be the fw, flash diff fw and see if it works, try ekknods free fw to test

Firmware compatibility problem, turn on the main, turn on the secondary and change firmware. Solve the problem

Quote:

Originally Posted by Fighters87 Firmware compatibility problem, turn on the main, turn on the secondary and change firmware. Solve the problem

I remember this happened when p1111 was on scamming me :saitama::saitama::kekw::kekw:

This happens with some motherboards and CPUs.

Flash standart fw from github onto your card then reboot and see if you can get into windows sound like a fw issue.

where did u get the card from?

Doesnt really matter, i dont know why people go for cheap shitty dma cards, you have lambda and ghost dma which is the best and most reliable, avoid going for weird shitty dma cards

Try the card on another pc to see if it’s a setup issue or a faulty card

Check your firmware

Quote:

Originally Posted by qu0n hi guys i got myself a dma card (35t phoenix). when i plug the card into my main pc and start it my windows hangs and does not boot. I have done all the bios settings bios update too new windows 10 pro installed the pc does not start ... when i press the button on the dma card my screen does not receive a picture and does not turn on ... I am completely new to this field :confused:...

I had a similar issue. I had to re flash the firmware to get it to work. Definitely reflash the fw properly and try again.