dma board question

When I turn on the DMA board and power it on(dma light is work), the main computer mouse and monitor don't work.
(fuzer light is no working)


When I turn off the DMA board power, the mouse and monitor work fine.
(fuzer light input1 input2 ouput1 is woking)


The bios settings is recent and line connections are fine.
i tried using another pcie slot
Disable Virtualization (INTEL), Disable VT-d,Disable Secureisable Boot set done

someone know this issue?

Quote:

Originally Posted by kling7837 When I turn on the DMA board and power it on(dma light is work), the main computer mouse and monitor don't work. (fuzer light is no working) When I turn off the DMA board power, the mouse and monitor work fine. (fuzer light input1 input2 ouput1 is woking) The bios settings is recent and line connections are fine. i tried using another pcie slot Disable Virtualization (INTEL), Disable VT-d,Disable Secureisable Boot set done someone know this issue?

The firmware loaded onto the DMA card may not be compatible with the motherboard or some other conflict causing the pc to not boot. Seen this a few times and you can reflash the card with new firmware. The main pc can be in any state (bios, not booted) just on and in jtag, ready to flash.

Quote:

Originally Posted by Ducks Services The firmware loaded onto the DMA card may not be compatible with the motherboard or some other conflict causing the pc to not boot. Seen this a few times and you can reflash the card with new firmware. The main pc can be in any state (bios, not booted) just on and in jtag, ready to flash.

This usually only occurs with “emulated” firmware. And the driver they’re using doesn’t like the motherboard or system. I’ve had it myself with a driver I used, but there’s many fixes to this

OP, send me PM. I’ve seen this issue a few times

Discord 1:1 messages are not being sent.
i created a ticket for an occlusion discord and then sent a message.
thank you