Hello, I just got my LeetDMA Pro V2 in the mail today and my PC won't boot while the card is on. If I enable the Killswitch it boots just fine, but I am only able to use tiny transfers with PCILeech. I think it's a firmware incompatibility issue with my motherboard but I am unable to flash new firmware using OpenBCD because I can't even open it.
I made sure virtualization and Vt-d were off. Disabled secure boot, set the pcie lane to x1, switched around different pcie slots, and nothing changed a damn thing. Even applied defaults in my bios.
Any ideas?
I made sure virtualization and Vt-d were off. Disabled secure boot, set the pcie lane to x1, switched around different pcie slots, and nothing changed a damn thing. Even applied defaults in my bios.
Any ideas?