The stall interface is replaced with the old interface

I want to change the V16 booth interface to the old interface, have you taught me the following? Thank you I want to change the picture 1 to picture 2

Figure one
[Only registered and activated users can see links. Click Here To Register...]

Figure II
[Only registered and activated users can see links. Click Here To Register...]


thank you very much

There is a lot to edit to make that old window work again..
But.. if you really want to do that change..
Here are some tips..
Searching for "__S8_VENDOR_REVISION" in source gives you a hint of where the new vendor app is coded over the old..

Removing all __S8_VENDOR_REVISION will give you this error when trying to open vendor:
2021/10/24 02:26:58 GetDlgItem : nID=516 not Found.

If you can fix that it should work, dont know, did not go that far to try that out..

If you manage to find that error and fix it and it still does not work..
You can look in to a older source (v5/v6) since I believe new shop didnt start until v10.. I could be wrong tho..

Here is a link to v5/v6 source
[Only registered and activated users can see links. Click Here To Register...]
Password: nana1206

Good luck!

Quote:

Originally Posted by dpkidz There is a lot to edit to make that old window work again.. But.. if you really want to do that change.. Here are some tips.. Searching for "__S8_VENDOR_REVISION" in source gives you a hint of where the new vendor app is coded over the old.. Removing all __S8_VENDOR_REVISION will give you this error when trying to open vendor: 2021/10/24 02:26:58 GetDlgItem : nID=516 not Found. If you can fix that it should work, dont know, did not go that far to try that out.. If you manage to find that error and fix it and it still does not work.. You can look in to a older source (v5/v6) since I believe new shop didnt start until v10.. I could be wrong tho.. Here is a link to v5/v6 source [Only registered and activated users can see links. Click Here To Register...] Password: nana1206 Good luck!

thanks