i need. Extractor.exe can open .pk2 with a 4 character password

Close

Try this one: [Only registered and activated users can see links. Click Here To Register...].

You cannot just edit the ASCII of the blowfish key "169841", because if you edit it to "1234", you will have 2 empty spaces at your ASCII. So you have to adjust a new ASCII address and edit the comparison address to your new ASCII blowfish key address.

close

Quote:

Originally Posted by hieulovehoa HELP ! Please share or guide extract file .pk2 has password <6 characters or more than 6 characters, thank!

Check out the file I shared again, I edited the link: [Only registered and activated users can see links. Click Here To Register...].


Guide:

First, you're gonna open x64dbg as administrator and choose your file to edit.



Go to the address, I gave you which will switch the memory region by pressing: CTRL + G then put your address (0x0007F700).



Then go to the very bottom and choose any empty area like (001107C4), remember the address because its your ASCII address and press: CTRL + E.



Anything written at ASCII, write your blowfish key, then click OK. It should look like this:



We'll go back to our comparison address (0x0007F700) and press: Space. It will look like this:



Switch 1125A4 with our new ASCII address, 001107C4, 1107C4.
So, it should look like:Click assembly or press Enter.

You can see 1234 at the comment, which is the new blowfish key.



Then save like this:

close

Contact me on discord, I wanna test it. (HB#9628)

close