what is the use of chat commands !!:
By using chat commands you can control other chars while you only need to have one SRO_Client opened (you can turn it off and use the chat tab in the mbot, just keep one client opened to make sure everything is working fine)
what is necessary for mbot commands to work :
1- enable the (Allow chat commands) in the party tab in the receiver's mbot (the one who gets the orders) .
2- the Commander char ( the one who gives or sends orders :D) must be in the party list or the receiver's mbot , so that not any player could be able to send commands to your chars.
3- the char commands must start with (cmd) , if you used space before (cmd) it won't work
what are the available commands or orders :
1- scroll
The char will attempt to use a return scroll
2- trace [<name>]
The receiving char will trace the char <Name>.
If <Name> is not supplied then the sending char will be traced.
3- sit
The char will sit down / stand up
(note: after the sit command , the bot will probably stop training
so you will have to press start training button in the mbot again)
4- leave
The char will leave its current party
5- move [<x> <y>]
Will move to the position of the sender of the command.
If <X> and <Y> are given, will move to this position instead.
6- join <x>
Attempt to join party number <X> from party matching.
7- invite [<name>]
Invite player <Name> into party.
If <Name> is not given, will invite the sender of the command.
Examples :
you might wanna wait 3 to 5 seconds between every command and the other.
you can use (General, PM, Party, Guild, Union, Global, Academy, ...) chat
but i prefer the PM chat , more specific about the receiver char that i'm sending the order to
By using chat commands you can control other chars while you only need to have one SRO_Client opened (you can turn it off and use the chat tab in the mbot, just keep one client opened to make sure everything is working fine)
what is necessary for mbot commands to work :
1- enable the (Allow chat commands) in the party tab in the receiver's mbot (the one who gets the orders) .
2- the Commander char ( the one who gives or sends orders :D) must be in the party list or the receiver's mbot , so that not any player could be able to send commands to your chars.
3- the char commands must start with (cmd) , if you used space before (cmd) it won't work
what are the available commands or orders :
1- scroll
The char will attempt to use a return scroll
2- trace [<name>]
The receiving char will trace the char <Name>.
If <Name> is not supplied then the sending char will be traced.
3- sit
The char will sit down / stand up
(note: after the sit command , the bot will probably stop training
so you will have to press start training button in the mbot again)
4- leave
The char will leave its current party
5- move [<x> <y>]
Will move to the position of the sender of the command.
If <X> and <Y> are given, will move to this position instead.
6- join <x>
Attempt to join party number <X> from party matching.
7- invite [<name>]
Invite player <Name> into party.
If <Name> is not given, will invite the sender of the command.
Examples :
you might wanna wait 3 to 5 seconds between every command and the other.
you can use (General, PM, Party, Guild, Union, Global, Academy, ...) chat
but i prefer the PM chat , more specific about the receiver char that i'm sending the order to