ROF

would anyone mind helping me figure this one out?

I've seen two hints, search for the float 1.0 and BFR

my guess is to search for the float of 1.0, then get in a BFR and then sub search for different from before

Guess ill mess around with this tonight and see if I get any results

I found an address that was .5 when ever I was in the BFR and I'm guessing thats what I'm looking for (another hint)

but when I'm trying to get the poke from the inject its giving me the error that it you cant have float values in commands...

any suggestions?

Ok so now I have 2 Hit addresses, one that shows up when I get into the BFR, and one that shows up when I get out.

should I try and inject "MOV EBX, 1" into the one where I'm out of the BFR?

Wrong j00b, its not going to be a MOV Offset...

someone was telling me you inject an MOV with the speed at the end of the disassembly?

No thats not what i meant, what i was saying is one method is change it too a mov. I will pm you the whole address and eveythign in just a min.

thanks for all the help laughing

im workin on same thing will you send me that info also? thanks in advance

I could help you out on vent/in game

I'm also trying to get this to work. I found the two addresses and codecaved them etc. However, each time I try it gives me an error :confused:.

I'd also love for someone to PM me the ventrilo info for the hacking group. It'd be interesting to see what we can do collectively!

-Mojo

you need to figure out what to inject

Quote:

Originally Posted by j00b you need to figure out what to inject

I've found the actual code address. I just keep finding two of the same type addresses and I can't figure out what to inject where? I'ved tried 9 different attempts, 7 didn't work and 2 froze my computer.

I'll Pm you what I've found thus far, and hope you can fill in the blanks!! :D

Ive been working on this one too trying to figure it out as well. Been playing with it for a while in the BFR. i narrow down to about two-six codes on average and been playing with them but to no result.

Couple of crashes and and some non inportant things happend. I read somewhere about the Float value of 1.0, but cant figure out what to do with the codes let alone tell if i have the right one. I dont like begging but if anyone could offer me addvise or tell me where im going wrong?

you should only get 4 codes at the end......make sure you pick the right one. or there will be some unwanted variables.