Heres how to make one also to edit the ips of the loopback adapter
How to make loopback adapter:
To manually install the Microsoft Loopback adapter in Windows XP, follow these steps:
1. Click Start, and then click Control Panel.
2. If you are in Classic view, click Switch to Category View under Control Panel in the left pane.
3. Double-click Printers and Other Hardware, and then click Next.
4. Under See Also in the left pane, click Add Hardware,and then click Next.
5. Click Yes, I have already connected the hardware, and then click Next.
6. At the bottom of the list, click Add a new hardware device, and then click Next.
7. Click Install the hardware that I manually select from a list, and then click Next.
8. Click Network adapters, and then click Next.
9. In the Manufacturer box, click Microsoft.
10. In the Network Adapter box, click Microsoft Loopback Adapter, and then click Next.
11. Click Finish.
How to change loopback adapters ip:
- Click on "My Network Places"
- "Network Connections" you will see it at the side on the menu
- Then just right click on loopback click on properties highlight "Internet Protocol" then click on properties again it will take you into the menu where to change the ips.
