Zur 1.1er Geht er IMMER zu den NPCs? Wenn ja hast du was falsch umgeprogt. Der erkennt ja an den weissen Rechtecken auffer map wo er steht da du ne andere Auflösung hast musst du das auch ändern sonst weiss er nicht wo er steht und geht zu den NPCs wenn du aber meinst, dass er relativ oft dahin geht ja das ist normal.Quote:
also 1.1 version klappt bei mir supa :D auch aufm laptop..hab das für den was umgeschrieben weil ich da 1280*800 habe...aber gibt noch nen paar unklarheiten
bei der 1.1 läuft der bei mir immer über die npc*s ist das normal?
und bei der 1.2 geht der nur zur gh wieder nach luts und zur gh ..der startet den run garnet flaggt noch nichtmal die heros?!?
mfg 63rrit
HFFF Bot
03/30/2008 12:44
Gabba2#331
03/30/2008 18:12
63rrit#332
danke
aber könnte mir auch jemand sagen welche koordinaten ich für welche zeile brauche?
es gibt da ja nen großen und nen kleinen weiß eingefärbten balken auf der map..und bei welchen pixelsearch function muss ich welche koordinaten eingeben?!?
sry aber kenne mich net so gut mit pixelsearch aus^^
aber könnte mir auch jemand sagen welche koordinaten ich für welche zeile brauche?
es gibt da ja nen großen und nen kleinen weiß eingefärbten balken auf der map..und bei welchen pixelsearch function muss ich welche koordinaten eingeben?!?
sry aber kenne mich net so gut mit pixelsearch aus^^
03/30/2008 18:45
MasteR GunneR#333
afaik sind das $north, $south und $middle. Zeilen weiß ich gerade nicht auswending.
Musst Pixel finden die immer nur bei einem Spawnpunkt weiß sind bei den anderen aber nicht.
Musst Pixel finden die immer nur bei einem Spawnpunkt weiß sind bei den anderen aber nicht.
03/30/2008 19:48
djsylver#334
danke für die neue Version :)
aber ein Problem habe ich und zwar bleibt der wieder öfter am Mast hängen und läuft teilweise seitlich zur Wand nach draussen, hattest du das nicht gefixt?
PS: Ist wegen deinem Bot eigentlich schon mal jemand gesperrt worden?
aber ein Problem habe ich und zwar bleibt der wieder öfter am Mast hängen und läuft teilweise seitlich zur Wand nach draussen, hattest du das nicht gefixt?
PS: Ist wegen deinem Bot eigentlich schon mal jemand gesperrt worden?
03/30/2008 21:06
Gabba2#335
JaQuote:
PS: Ist wegen deinem Bot eigentlich schon mal jemand gesperrt worden?
(Ich liebe Einzeiler^^)
03/31/2008 01:10
Sleipnir Xiv#336
Nun ja, zumindest läuft deiner immer gegen die Fahnenstange, wie man das so sieht nachts XD.Quote:
[...]
03/31/2008 01:48
DarksSaber#337
Do you think you could post the how to txt file in english?
the coordinates for clicking in the box where you type your name in to turn in faction is still in the wrong place for me. its been like that in every version so i've just been fixing it myself. anyone else having the same problem?
Its also still adding Xandra instead of Vekk. Tried changing the numbers in the settings file around but still can't figure it out so if anyone has the correct coordinates, could you post it?
the coordinates for clicking in the box where you type your name in to turn in faction is still in the wrong place for me. its been like that in every version so i've just been fixing it myself. anyone else having the same problem?
Its also still adding Xandra instead of Vekk. Tried changing the numbers in the settings file around but still can't figure it out so if anyone has the correct coordinates, could you post it?
03/31/2008 09:36
VegetaLord#338
wenn ich emotes deaktiveren will was gibt man bei der abfrage über settings ein ?
da nur die möglichkeit "1" angegeben ist zum verwenden von emotes
garnix ? oder nee 0 ?
thx im vorraus
da nur die möglichkeit "1" angegeben ist zum verwenden von emotes
garnix ? oder nee 0 ?
thx im vorraus
03/31/2008 10:02
tom_bootsy#339
Hello,
I am having 2 problems;
1. Occasionally the bot will get stuck on the left side of the wall when running up the stairs out to Malandru’s. Then the bot will do some random clicks (I’m not sure if these are supposed to take us to Guild Hall and then back to Lutgardis, as this might fix the problem), then bot will attempt to re-add the henchman, which consequentially removes them from the party (as they are still in it, while it does this). After that the bot will usually make its way out to Malandu’s by going to the Malandru’s post and then out the portal, but unfortunately it no longer has the henchmen to flag to bridge, so it continues running as it would if it had the henchmen.
2. I’m not sure if this was a one off thing, but when it opens the map and clicks on a town to dump the faction at, a message comes up saying that, “ Your party is too large to travel there. Do you wish to leave your party and travel separately there?” But the bot didn’t click anything, so it ended up taking me to the various places and back to Lutgardis, and begun running without dumping.
Thank you
I am having 2 problems;
1. Occasionally the bot will get stuck on the left side of the wall when running up the stairs out to Malandru’s. Then the bot will do some random clicks (I’m not sure if these are supposed to take us to Guild Hall and then back to Lutgardis, as this might fix the problem), then bot will attempt to re-add the henchman, which consequentially removes them from the party (as they are still in it, while it does this). After that the bot will usually make its way out to Malandu’s by going to the Malandru’s post and then out the portal, but unfortunately it no longer has the henchmen to flag to bridge, so it continues running as it would if it had the henchmen.
2. I’m not sure if this was a one off thing, but when it opens the map and clicks on a town to dump the faction at, a message comes up saying that, “ Your party is too large to travel there. Do you wish to leave your party and travel separately there?” But the bot didn’t click anything, so it ended up taking me to the various places and back to Lutgardis, and begun running without dumping.
Thank you
Just open the code for the bot (.au3 file) then save it to desktop. Open that code on the desktop, press Ctrl + F and type Vekk, then for Acolyte, Zhed and Vekk change where it says "not found" to 390, 445 and 838 respectivley and save it. now when you want to run the bot use this script (Run Script, AutoIt v3 program) and it should invite vekk instead of xandra, well atleast that is what i did, hope it helps.Quote:
Its also still adding Xandra instead of Vekk. Tried changing the numbers in the settings file around but still can't figure it out so if anyone has the correct coordinates, could you post it?
03/31/2008 15:40
Phil88#340
Ist das bei der 1.2 version immer noch so das der run versagt wenn der tiger draußen ist ?
03/31/2008 16:50
MasteR GunneR#341
Sure I can - but, you now, I'm not a native speaker so it would take me some time that I really haven't got at the moment. I'm sorry about that.Quote:
Geb alles ein was du willst außer eine "1" :>Quote:
Quote:
I am having 2 problems;
1. Occasionally the bot will get stuck on the left side of the wall when running up the stairs out to Malandru’s. Then the bot will do some random clicks (I’m not sure if these are supposed to take us to Guild Hall and then back to Lutgardis, as this might fix the problem), then bot will attempt to re-add the henchman, which consequentially removes them from the party (as they are still in it, while it does this). After that the bot will usually make its way out to Malandu’s by going to the Malandru’s post and then out the portal, but unfortunately it no longer has the henchmen to flag to bridge, so it continues running as it would if it had the henchmen.
It should open your guild window and take you to your Guild Hall, yes.
Bind "open guild window (I duno the exact name)" to "G" if you haven't done it already and place the window in the upper left corner (should be as high as possible and as small as possible).
2. I’m not sure if this was a one off thing, but when it opens the map and clicks on a town to dump the faction at, a message comes up saying that, “ Your party is too large to travel there. Do you wish to leave your party and travel separately there?” But the bot didn’t click anything, so it ended up taking me to the various places and back to Lutgardis, and begun running without dumping.
This message should be "spaced" away (the bot actually is hitting space two times to get there). Maybe there's some option deactivating this or the bot hits the button to fast for your mashine (what I doubt).
Thank you
War (oder sollte) zumindest schon seit 1.1 nicht mehr der Fall sein.Quote:
03/31/2008 16:58
Gabba2#342
Uäh meiner? oO Also eigentlich kann das nich sein. Meiner rennt zwar zur Fahnenstange aber nich dagegen ausser er hat nen Fehler und auch dann sollte er das eig. nicht öfter als 1 mal in Folge machen.Quote:
€ Ich seh grad, dass ich die Func gar nimma bei mir drin hab also kann ichs eig nich gewesen sein^^ Ausser es war so heavy am laggen wobei man da ja eher langsamer als schneller wird.
03/31/2008 23:57
tom_bootsy#343
So it is supposed to take me to Guild Hall and then straight Back to Lutgardis? Because usually it will attempt to correct itself when it gets stuck at this point by re-inviting the Henchmen, which kicks them because they were already in the party. Then it usually manages to get out to Malandru's and continues running, without the Henchmen. Or, it will get stuck again and then take me to Guild Hall, Random Areana, Kaining and then back to Lutgardis which it is supposed to because that fixes it. (yes i have the correct setup as everything eles works perfectly fine accept for when it gets stuck at this excate point on the left side of the stairs)Quote:
It should open your guild window and take you to your Guild Hall, yes.
Bind "open guild window (I duno the exact name)" to "G" if you haven't done it already and place the window in the upper left corner (should be as high as possible and as small as possible).
Thanx for the reply MasteR GunneR
04/01/2008 23:58
jazdeep#344
Hey, all is working well accept that it doesn't make it to 10k usually about 8.8k then dumps, how do i change the number of runs that the bot will do ?
$runstotal = 27 (line 2294) is this the number i edit or is there more to it than that ?
Thank You.
$runstotal = 27 (line 2294) is this the number i edit or is there more to it than that ?
Thank You.
04/02/2008 14:24
MasteR GunneR#345
That's it.
(+1)
(+1)