Just do it like this
On 2nd PC or VMWARE: (This is the pc that will run the radar)
Step 1: Search and run "cmd" - This should open the command prompt.
Step 2: type "ipconfig" and press enter.
Step 3: Take note of your IPv4 address for VPN Settings on gaming pc.
Step 4: Take note of your default gateway.
Step 5: Search and run "ncpa.cpl"
Step 6: Right click your primary internet adapter, then click properties.
Step 7: Select "Internet Protocol Version 4 (TCP/IPv4)"
Step 8: Use "Obatain an IP address automatically" and "Obtain
DNS server address automatically"
Step 9: Click "OK"
Step 10: Uncheck "Internet Protocol Version 6 (TCP/IPv6)
Step 11: Click OK. - The PC may need up to 10 minutes for settings to refresh.
Step 12: On your keyboard, Press ALT - File will now appear on the top left.
Step 13: Click File, Then click "New Incoming Connection"
Step 14: Add someone (bottom left) - Make username and password - click ok - Then click Next.
Step 15: Checkmark "Through the Internet" - Then click Next.
Step 16: Select "Internet Protocol Version 4 (Already selected by default, make sure it is checkmarked" Then select "properties"
Step 17: Make sure "Network Access" is checked
Step 18: Under "IP address assignment" Check "Specifiy IP Addresses"
Step 19: Use your Default Gateway from earlier, to create a proper IP range for "Specify IP addresses"
For instance: if gateway is 192.168.0.1 - use 192.168.0.2 to 192.168.0.10 for
the ip range. - Then select "OK"
Step 20: Select Allow Access
Step 21: DONE. Now to setup the Gaming PC.
On Gaming PC: (This is the PC that will run PUBG)
Step 1: Search and run "ncpa.cpl"
Step 2: Right click your primary internet adapter, then click properties.
Step 3: Select "Internet Protocol Version 4 (TCP/IPv4)"
Step 4: Use "Obtain an IP address automatically" and "Obtain DNS server address automatically"
Step 5: Click "OK"
Step 6: Uncheck "Internet Protocol Version 6 (TCP/IPv6)
Step 7: Click OK. - The PC may need up to 10 minutes for settings to refresh. Now close out the "Network Connections" window.
Step 8: Click your windows button (default location bottom left)
Step 9: Click the settings cog
Step 10: Click "Network & Internet"
Step 11: Click "VPN" on left side
Step 12: Click "Add a VPN Connection" on the top
Step 13: Use these settings:
VPN Provider: Windows (built-in)
Connection name: Random name
Server name or address: Insert 2nd PC IPv4 address from cmd prompt on 2nd pc
VPN type: PPTP
User name: User you made on incoming connections on 2nd pc
Password: Password you made on incoming connections on 2nd pc
Click Save.
Step 14: Connect to the VPN that you created.
Step 15: If you were able to connect, you are done!
I set up my IP and I got this error " Cannot save setting file to C:\User\mania\.pubgradar\setting.properties "