does it work for xp?
Yes, it does.Quote:
does it work for xp?
Quote:
It seems that you guys found a good way to raise post counts. No offense cause all the post contains the same info i.e Inject at step 10 99%
This is not a universal solution cause a lot of users can't manage to do it correctly. So if anyone who can't run the IM in this newly discovered way, please don't spam the pages?
A Little Theoretical Explanation
After HGWC's step 10 99% The S4Client.exe process is launched. What the injector did is inject the .dll right after the HGWC was done loading and s4client.exe started. So it's not a matter of 'wait for 2 sec after hgwc step 10 99%' Cause a slower computer may take more than 2 sec to load s4client.exe after step 10, on the contrary a relatively faster computer loads s4client.exe in less than a second after the step 10
So if you want to give this new method a try, you have to observe quiet minutely exactly when the s4client.exe process launches, and start the IM at that time. But you have to be Mr.Qu!ckF!ngers to do this, so Good Luck
Don't mimimimimimi here please, cause things are getting out of hand.
here's the easy way to do it, just when you're at step 10, 99% ... highlight the IM.exe then spam "ENTER" ...Quote:
It doesn't work.
It says I need to run as an admin.
I run it at step 10 like everybody says.
Then it says unknown error = Error 8
I managed to run it once, but I don't know how.
We all are saying that,when i am at school and when i come back i check all the posts that were writen when i was at school,I think some of them are too lazy to see them,no offend but if you want IM to work,you must xcheck posts that were left before u!Quote:
OMG i think WHY you easly don't go to see the past posts for see how to make it work before say "it don't work" ??? .-. *facepalm*
It's the same method , but you need to open ItemManager on STEP 10 99% on the HGWC loading bar or you'll get the Admin Error...Quote:
YAY thx Mister smith *-* finally a working one again, took me hours to find... btw is it still the old method? i am learning c++ right now, and i think with adresses and bypass it would simply be reading the values of the adress by using a pointer, saving this as a variable and then writing the saved values into the same adress this pointer is referring to... just guessing though. or is there any other trick to it?
S4Tomate doesn't works for me so I can't really provide any kind of support for it. Sorry for that mate..Quote:
Just one question:
If i use the normal itemmanager.exe and hit it right at 99% it gives me unknown error 08.
I know that one is supposed to try it over and over but i tried 40 times now, still not worked. After that I wanted to inject it with S4tomate but well... it gives me running and everything... but the Manager just won't show up ._. any suggestions?
(BTW YES i put S4Tomate.exe and IM.dll into the BGM folder and YES i pressed autoinject after step5 AND i waited about 30 minutes ingame...)